20-Dec-2024
a complete detection & suppression system for CNC machines
What is CNC Machine Fire Suppression?
Fire Engineering Technology supply and install a series of Automatic Fire Suppression Systems which are specifically designed to protect all types of industrial machinery such as CNC machines. This gives you peace of mind that you are not only meeting all current NFPA guideline and NBC code : Chapter iv- Fire and life Safety Regulations in the workplace, but more importantly you are protecting your operators from the risk of machinery fire.
Automated machines such as CNC machines are often left unattended to operate for long periods or even to run throughout the night. If there was a fault, a safety cut out would probably stop the machine running, but what would happen if a fire broke out whilst it was unattended? Or even if the operator was there but the fire was severe?
This would be a major fire risk, however installing an Automatic Fire Suppression System would remove this, safely extinguishing the fire, protecting both life, machinery and buildings.
Key Points:
A complete system, ready to be installed
Pre-engineered for CNC machines
Design to be used with CO2 extinguishing agent (cylinders are unfilled when delivered)
Cylinders supplied in both 4.5Kg and 9Kg sizes
Also suitable for use with the Master Control Unit system
Our Automatic Fire Suppression Systems use our specially designed linear detection tubes which are installed in all areas at risk around the machine. This means that a fire can quickly be detected without the use of conventional electronic detectors, therefor removing the need for any independent power supply or battery back-up but more importantly it means the system is utterly reliable as there are minimal components.
A simple explanation of how Automatic Fire Suppression Systems work is that the detection tubes are filled with nitrogen to the correct pressure which will hold the extinguisher valves in the closed position. If a fire breaks out the temperature will increase, this causes the nitrogen to expand and the pipe to burst, allowing the extinguisher valve to open.
As CNC Machines are used for a range of applications, FET can provide you with the correct type of extinguishant to suit your set-up. In addition to this, the Automatic Fire Suppression System can easily be integrated to work in conjunction with the machines own emergency stop circuit, alarm or extraction system. So for example, if the tube burst through fire, or there was a loss of nitrogen, reducing the pressure, an additional switch connected to the nitrogen filled tube would be triggered, causing the machine to automatically stop.
Want to know more about our products.. fill the form below
